Boot up with your Windows Boot Disc. 

1. At the A:\ prompt type fdisk. 
2. Choose option 2- delete a Primary Dos Partition
3. Choose option 3- Create a Primary Dos Partition

INSTALLING WINDOWS 98

1.       Insert the Start Disk into the floppy drive

2.       Turn on the monitor and the computer

3.       Allow the system to load DOS

NOTE:   A message like A:\>_ will appear on the bottom left side on the screen.

4.       Partition and format the hard-disk drive using the Start Disk/boot disc

NOTE: DO NOT REMOVE THE START DISK FROM THE FLOPPY DRIVE

5.       Restart the system (use CTRL+ALT+DELETE or RESET button)

6.       Allow the system to load DOS

7.       Type X:\ (where X indicates CD-ROM drive, for example D:\) and press ENTER

TIP: The letter assigned to the CD-ROM drive can be found after the DOS has been loaded

8.       Type CD WIN98 and press ENTER

9.       Type SETUP and press ENTER

10.   Wait few seconds and press ENTER again

NOTE: Scandisk will automatically check the HARD-DISK drive for any errors.

11.   After Scandisk has checked the drive for any errors, Windows 98 Setup will appear

12.   Click on “CONTINUE”

13.   Click on “NEXT”

14.   Select “TYPICAL” and click on NEXT

15.   Select “Install the most common components” and click on NEXT

16.   Choose a name for your computer and click on NEXT

NOTE:  (Leave the Workgroup as is.)

17.   Click on NEXT

18.   Click on NEXT (Wait few seconds)

19.   Click on CANCEL then click on OK

20.   Click on NEXT (This process will take about 20-30 minutes)

NOTE: You will be prompted to remove any floppy or CD disks from the drive. Do so.

      The computer will reboot.

21.   Type the USER INFORMATION inside the boxes and click on NEXT

22.    Type the PRODUCT KEY and click on NEXT

23.   Click on FINISH

24.   Set the TIME and DATE correctly, and click on OK

25.   Follow any further on-screen instructions.